Landice L10, Руководство по обслуживанию

Страница: 45 / 66

45
Drive Belt Installation & Removal
Drive Belt Installation/Removal Instructions
INTRODUCTION: This document is for the installation and removal of the drive belt (#10030)
TOOLS REQUIRED:

5mm Allen Wrench

½” Socket & Socket Wrench
BEFORE YOU BEGIN: You will need to remove the motor cover, upright end cover caps, and side
frame cover (Left Side Only) to gain access to the drive belt. Please refer to the individual instructions for
both Motor Cover Removal and Side Frame Removal if you need assistance
.
Step 1
Using a ½” socket wrench, loosen and remove the front roller adjustment bolt, as shown in Illustration A .
Remove the bolt, washer and spring, and then remove the J-hook. Using a 5mm Allen Wrench, loosen
and remove the bolt holding the drive motor in place, as shown in Illustration B.
Step 2
With the bolts on both sides removed, remove the drive belt next. Work it slowly off the drive motor
shaft, as shown in Illustration C , being careful not to damage the drive belt. You can then lift the drive
roller out of the left side insert, and remove the drive belt from the roller, as shown in Illustration D.
It is recommended to tighten the drive roller adjustment bolt to 30 foot pounds.
To install the drive belt, please reverse the steps shown here.
A
B
C
D