Landa MHC3-24324, Руководство оператора, Страница: 14 / 25

14
Operations
Detergents And General Operating
Techniques
WARNING: Some detergents may
be harmful if inhaled or ingested,
causing severe nausea, fainting or
poisoning. The harmful elements
may cause property damage or
severe injury.
AVERTISSEMENT: Certains
détergents peuvent être
dangereux s'ils sont inhalés ou
ingérés, provoquant de fortes
nausées, des évanouissements et l'empoisonnement.
Les éléments dangereux peuvent causer des
dommages à la propriété ou des blessures graves.
STEP 1: Use detergent designed specifically for pressure
washers. Household detergents
could damage the pump. Prepare
detergent solution as required by the
manufacturer. Fill a container with
pressure washer detergent. Place
the filter end of detergent suction
tube into the detergent container.
STEP 2: Apply safety latch to spray
gun trigger. Secure black detergent
nozzle into quick coupler. NOTE:
Detergent cannot be applied using
the Yellow nozzle.
STEP 3: With the motor running, pull
trigger to operate machine. Liquid
detergent is drawn into the machine
and mixed with water. Apply
detergent to work area. Do not allow
detergent to dry on surface.
IMPORTANT: You must flush the detergent injection
system after each use by placing the suction tube into
a bucket of clean water, then run the pressure washer
in low pressure for 1-2 minutes.
Thermal Pump Protection
If you run your pressure washer for 3-5 minutes without
pressing the trigger on the spray gun, circulating water in
the pump can reach high temperatures. When the water
reaches this temperature, the pump protector engages
and cools the pump by discharging the warm water onto
the ground. This thermal device prevents internal damage
to the pump.
Cleaning Tips
Pre-rinse cleaning surface with fresh water. Place
detergent suction tube directly into cleaning solution and
apply to surface at low pressure (for best results, limit your
work area to sections approximately 6 feet square and
always apply detergent from bottom to top). Allow
detergent to remain on surface 1-3 minutes. Do not allow
detergent to dry on surface. If surface appears to be
drying, simply wet down surface with fresh water. If
needed, use brush to remove stubborn dirt. Rinse at high
pressure from top to bottom in an even sweeping motion
keeping the spray nozzle approximately 1 foot from
cleaning surface. Use overlapping strokes as you clean
and rinse any surface. For best surface cleaning action
spray at a slight angle.
Recommendations:
• Before cleaning any surface, an inconspicuous
area should be cleaned to test spray pattern and
distance for maximum cleaning results.
• If painted surfaces are peeling or chipping, use
extreme caution as pressure washer may remove
the loose paint from the surface.
• Keep the spray nozzle a safe distance from the
surface you plan to clean. High pressure wash a
small area, then check the surface for damage. If
no damage is found, continue to pressure
washing.
CAUTION - Never use:
• Bleach, chlorine products and other corrosive
chemicals
• Liquids containing solvents (i.e., paint thinner,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products or acid-based products
These chemicals will harm the machine and will
damage the surface being cleaned.
ATTENTION: Ne jamais utiliser:
• Eau de Javel, produits à base de chlore et
autres produits chimiques corrosifs
• Liquides contenant des solvants (c.-à-d.
diluant à peinture, essence, huiles, etc.)
• Produits à base de tripolyphosphate de sodium
• Ammoniac ou produits à base d'acide
Ces produits chimiques endommageront la machine
et endommageront la surface étant nettoyée.
PRECAUCIÓN: Nunca utilice:
• Blanqueadores, productos con cloro u otros
químicos corrosivos.
• Solventes (por ejemplo: diluyente de
pintura, gasolina, aceites).
• Productos de fosfato trisódico.
• Productos de amoniaco.
• Productos a base de ácido.
• Estos químicos provocaran daño en la
máquina y dañarana superficie que se está
limpiando.
Landa MHC 9.800-950.0 - BM
WARNING