Section 1: Assembly & Set-up
SA20 Hydraulic Post Hole Diggers 317-215M
3/8/18
11
Hydraulic Hose Assembly For Tractors
Figure 1-7
9.
Screw 90
o
elbow (#8) to adapter (#9). Draw elbow up
snug with open end up. Do not tighten at this time.
10. Insert hydraulic hoses (#10) through hose guide (#3)
as shown and screw to elbows (#8) until tight.
11. Tighten elbows (#8) to adapters (#9).
12. Replace hose cover (#1) and secure with existing
5/16"-18 x 5/8" GR5 hex flange serrated bolts (#6).
13. Tighten bolts (#6) to the correct torque.
“Auger Assembly & Disassembly”
8 Foot Hose Assembly for Skid Steers
Refer to Figure 1-8:
1.
Remove bolts (#6) and hose cover (#1).
2.
Remove plug from motor port “A” and screw o-ring
end of straight adapter (#9) to motor port “A” until
tight.
3.
Screw 90
o
elbow (#8) to adapter (#9). Draw elbow up
snug with open end up. Do not tighten at this time.
4.
Remove plug from motor port “B” and screw o-ring
end of straight adapter (#9) to motor port “B” until
tight.
37269
NOTE:
Use Land Pride’s 90
o
elbows (#7) if
attaching to Kubota CTL.
Hydraulic Hose Assembly For Skid Steers
Figure 1-8
5.
Screw 90
o
elbow (#8) to adapter (#9). Draw elbow up
snug with open end up. Do not tighten at this time.
6.
Insert hydraulic hoses (#12 & #13) through hose
guide (#3) in gearbox housing and screw hoses to
elbows (#8) until tight.
7.
Tighten elbows (#8) to adapters (#9).
8.
Thread hoses (#12 & #13) through left-hand hose
guide (#2) as shown.
9.
Screw MJIC end of 90
o
elbows (#7) to hydraulic
hoses (#12 & #13) until tight.
10. Select male coupler (#10) or female coupler (#11)
that mates with skid steer’s high pressure coupler.
Hose (#13) is attached to motor port “A”. Attach
selected coupler to hydraulic hose (#13) and tighten.
11. Hose (#12) is attached to motor port “B”. Screw
remaining coupler to hydraulic hose (#12) until tight.
12. Replace hose cover (#1) and secure with existing
5/16"-18 x 5/8" GR5 hex flange serrated bolts (#6).
13. Tighten bolts (#6) to the correct torque.
14. Continue with
“Auger Assembly & Disassembly”
37270
NOTE:
Flat face couplers (#10 & #11) and 90
o
elbows (#7) are optional. See
23 for additional information.