Land Pride SA20 Series, Руководство оператора

Страница: 12 / 38

Section 1: Assembly & Set-up
Table of Contents
SA20 Hydraulic Post Hole Diggers 317-215M March 8, 2018
8
Hook-Up Bucket Mount Post Hole Digger
Figure 1-3
Hook-Up Bucket Mount
If Post Hole Digger is already attached to the bucket, skip
to
“Hook-Up Hydraulic Hoses to Tractor” on this page.
DANGER
!
To prevent serious injury or death:
Always shut power machine down using “Power Machine
Shutdown Procedure” on page 7 before dismounting the
power machine and/or allowing anyone to come near the
power machine and attachment.
Hook-Up Post Hole Digger to Bucket
Refer to Figure 1-3:
1. If removed, attach bucket mount (#2) to right- or left-
hand side of the bucket. See step 3 under
“Motor/
Gearbox Assembly” on page 7 for detailed
instructions.
2. Slowly approach Post Hole Digger with tractor and
bucket while using control levers to lower and align
bucket mount (#2) close to gearbox knuckle (#1).
3. Shut power machine down using “Power Machine
Shutdown Procedure” on page 7 before dismounting.
4. Manually align hole in knuckle (#1) with holes in
bucket mount (#2).
5. Insert clevis pin (#4) and secure with cotter pin (#3).
Bend both legs of cotter pin around clevis pin to keep
cotter pin from falling out.
37271
Hose Assembly For Bucket Mount
Figure 1-2
Hydraulic Hose Assembly
Refer to Figure 1-2:
1. Screw MJIC end of adapter fittings (#4) to one end of
292" long hydraulic hoses (#7) and tighten.
2. Screw quick release couplers (#8) to adapter
fittings (#4) until tight.
3. Remove bolts (#3) and hose cover (#1).
4. Remove plug from motor port “A” and screw o-ring
end of straight adapter (#6) to motor port “A” until
tight.
5. Screw 90
o
elbow (#5) to adapter (#6). Draw elbow up
snug with open end up. Do not tighten at this time.
6. Remove plug from motor port “B” and screw o-ring
end of straight adapter (#6) to motor port “B” until
tight.
7. Screw 90
o
elbow (#5) to adapter (#6). Draw elbow up
snug with open end up. Do not tighten at this time.
8. Insert opposite end of hydraulic hoses (#7) through
hose guide (#2) and screw hoses to elbows (#5) until
tight.
9. Tighten elbows (#5) to straight adapters (#6).
10. Replace hose cover (#1) and secure with
5/16"-18 x 5/8" GR5 hex flange serrated bolts (#3).
11. Tighten bolts (#3) to the correct torque.
12. Skip to “Auger Assembly & Disassembly” on
page 12.
37266
NOTE: Hydraulic hoses (#7), adapter fittings (#4),
and couplers (#8) are optional and may not be
included with the bucket mount assembly