Land Pride SA20 Series, Руководство оператора

Страница: 19 / 38

Section 1: Assembly & Set-up
Table of Contents
SA20 Hydraulic Post Hole Diggers 317-215M 3/8/18
15
Unhook Post Hole Digger
Refer to Figure 1-13 on page 14:
DANGER
!
To prevent serious injury or death:
A crushing hazard exists while hooking-up and unhooking
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate lift and/or tilt controls while
someone is near the power machine and/or attachment.
1. See “Long-Term Storage” on page 24 before
parking Post Hole Digger for a long time.
2. Park skid steer/tractor on a flat, level, solid surface,
and lower Post Hole Digger until skid/loader plate is
resting on the ground.
3. Shut power machine down using “Power Machine
Shutdown Procedure” on page 7 before dismounting.
4. Disconnect hydraulic couplers (#1A & #2A) from skid
steer/tractor.
5. Store hoses on the Post Hole Digger frame to keep
dirt away from the couplers.
6. Disengage lock pins to clear bottom slots in auger
hitch.
7. Restart skid steer/tractor and tilt top of skid/loader
plate
slightly forward.
8. Slowly lower skid/loader plate until it has separated
from the auger hitch top angle bar.
9. Back skid steer/tractor slowly away while making
sure the skid/loader plate does not interfere with Post
Hole Digger.
10. Repeat step 3 above to shut skid steer/tractor down
and dismount.
11. Check overturn stability of the unhooked Post Hole
Digger. Make sure the unit will not tip over. If needed,
add bracing to keep it from overturning.