Land Pride SA10, Руководство оператора

Страница: 14 / 38

Section 1: Assembly & Set-up
SA10 Hydraulic Post Hole Digger 317-433M 6/2/22
10
Table of Contents
Tractor Requirements
Sub-compact tractor horsepower should be within the
range noted below. Tractors outside the horsepower
range must not be used.
Horsepower Requirements: . . . . 15-35 hp (11-26 kW)
Hitch Category . . . . . . . Universal quick-attach mount
Hydraulic Outlets . . . . . . . . Loader 3rd function valve
Required Hydraulic Flow. . . . . . 4-8 gpm (15-30 Lpm)
Sub-compact tractor Weight . . . .See Warnings Below
WARNING
!
To prevent serious injury or death:
•
Consult your power machine Operator’s Manual for
operating capacity, lifting capacity, and operating
specifications. Exceeding rated capacities and
specifications can result in loss of control, roll-over or other
serious hazard.
•
Use a power machine of adequate size for the load being
carried. An undersized machine can roll over when raising
the loader arms due to high center of gravity.
•
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward and/
or side tipping. Consult your power machine Operator’s
Manual to determine proper weight requirements and
maximum limitations.
Torque Requirements
Refer to
“Torque Values Chart”
on page 32 to determine
correct torque values when tightening hardware.
Before You Start
Make sure the intended power machine conforms to the
requirements provided on this page. Also, read and
understand this Operator’s Manual for your Model SA10
Post Hole Digger. An understanding of how it works will
aid in its assembly and set-up.
Go through the
“Assembly Checklist”
on this page
before assembling the Post Hole Digger. To speed up
your assembly task and make the job safer, have all
needed parts and equipment readily at hand.
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1. Reduce engine speed and shut-off all power to the
attachment.
2. Park tractor and attachment on solid, level ground.
3. Lower attachment until it is flat on the ground or on
non-concrete support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7. Use steps, grab-handles and anti-slip surfaces when
stepping getting on and off the tractor.
Assembly Checklist

Check Ref.
Have a hoist, forklift, or loader with properly sized chains and
safety stands capable of lifting and supporting the equipment
on hand.
Have a minimum of two people available during assembly.
Make sure all major components and loose
parts are shipped with the machine. Assembly
& Set-up
Double check to make sure all parts, fasteners,
and pins are installed in the correct location.
Refer to the Parts Manual if unsure.
NOTE:
All assembled hardware from the factory
has been installed in the correct location.
Remember location of a part or fastener if
removed. Keep parts separated.
Parts Manual
317-433P
Operator’s
Manual
317-433M
Make sure working parts move freely, bolts are
tight & cotter pins are spread. Operator’s
Manual
Make sure all safety labels are correctly located
and legible. Replace if damaged.
Page 6
Make sure all grease fittings are in place and
lubricated.
Page 28
Section 1: Assembly & Set-up