Land Pride QH05 Series, Руководство оператора

Страница: 22 / 38

Section 1: Assembly & Set-Up
Table of Contents
QH05, QH16, QH20, & QH30 Quick Hitches 320-003M 7/15/22
18
Implement Hook-Up to QH30
Go to page 13 for “Implement Hook-Up to QH05”
Go to page 14 for
“Implement Hook-Up to QH16”
Go to page 16 for “Implement Hook-Up to QH20”
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
implement. Keep people and animals away while backing-up
to the implement or pulling away from the implement. Do not
operate hydraulic controls while a person or animal is directly
behind the power machine or near the implement.
CAUTION
!
To avoid minor or moderate injury:
Release Handles have areas where pinching can occur. Keep
hands, fingers, and other body parts away from the pivoting
areas of the release handles. Always use the handle grips.
Refer to Figure 1-9:
1. Make certain implement’s lower hitch pins are
secured in their respective clevises.
2. Place Quick Hitch release handles in the down
position as shown.
3. Carefully back tractor to align auto-lock hooks under
the implement’s lower hitch pins and upper hook
below upper hitch point.
4. Slowly raise 3-point lift arms until auto-lock hooks
lock onto the implement’s lower hitch pins and upper
hook captures implement’s upper hitch point.
NOTE: Quick Hitch hook-up to tractor is required
before proceeding with implement hook-up.
5. If required, follow implement guidelines for driveline
hook-up and required driveline length.
IMPORTANT:
Make certain lower hitch pins are fully
seated in the auto-lock hooks and captured with lock
arms above. Also, make sure upper hitch point is
captured in the Quick Hitch upper hook.
IMPORTANT:
When hooking-up a driveline, make
sure it is not too short to comply with shaft
overlapping guidelines. Refer to your implement
Operator’s Manual for driveline hook-up instructions.
Replace driveline shafts and shields if thy are too
short. See your nearest Land Pride dealer for new
shafts and shields.
Implement Hook-Up with QH30
Figure 1-9
Upper Hitch Point
Release Handle
Upper Hook
Auto-Lock Hooks
Lower Hitch Pin
70123