Land Pride QH05 Series, Руководство оператора

Страница: 21 / 38

Section 1: Assembly & Set-Up
Table of Contents
QH05, QH16, QH20, & QH30 Quick Hitches 320-003M 7/15/22
17
Hook-up Without Floating Top Links
Refer to Figure 1-7 & Figure 1-8 on page 16:
1. Make certain implement’s upper and lower hitch
pins are secured in their respective clevis.
2. Place Quick Hitch release handles in the down
position as shown.
3. Lower 3-point lift arms until auto-lock hooks are
below implement’s lower bushings (#1 or #3) and
upper hook is below upper hitch point.
4. Carefully back tractor to align auto-lock hooks under
implement’s lower bushings (#1 or #3) and upper
hook below upper hitch point.
5. Slowly raise 3-point arms until auto-lock hooks lock
onto the implement’s lower bushings (#1 or #3) and
upper hook captures implement’s upper hitch point.
6. If required, follow implement guidelines for driveline
hook-up and required driveline length.
IMPORTANT: Make sure lower hitch pins are fully
seated in the auto-lock hooks with auto locks
popped out over the hitch pins. Also, make sure
upper hitch point is fully captured in the Quick Hitch
upper hook.
IMPORTANT: When hooking-up a driveline, make
sure its maximum allowable length does not exceed
guidelines. For detailed instructions, refer to
“Driveline Hook-up”
in your implement Operator’s
Manual. Replace driveline if it is too short. See your
nearest Land Pride dealer for a new driveline.
Hook-up With Floating Top Links
1. Complete steps 1-6 on the left side of this page
except the tractor’s top center link must be shortened
to keep the Quick Hitch upper hook from capturing
the implement’s upper hitch point.
2. Attach floating top links to the Quick Hitch and
implement. Refer to
“Floating Top Link”
on page 23
for detailed instructions.