Land Pride HR35 SERIES, Руководство оператора

Страница: 16 / 24

Section 3: Adjustments
HR3584 & HRL3578 Retractable Box Scraper 305-054M 10/31/18
12
Table of Contents
Section 3: Adjustments
5. Rotate level 90 degrees and then adjust the tractor’s
top center link until unit is leveled from front to back.
Rear Blade Setting
Refer to Figure 3-2:
The rear gate of the Box Scraper is hinged. Mounted to
the rear gate is a rear blade. The cutting blade located in
front of the rear gate will penetrate deeper if the rear gate
is allowed to hinge.
For finishing and fine grading, secure both ends of the
rear gate to the moldboard with 1/2" x 1 1/2" long bolts
(1/2" bolts are supplied by customer).
Rear Blade Setting
Figure 3-2
NOTE: Through extensive research and testing,
Land Pride has designed the optimum cutting angle
into your Box Scraper. If needed, shorten top center
link one-half turn at a time to increase blade pitch.
For Finishing and Fine Grading,
Secure Rear Gate at Both Ends
With 1/2" x 1 1/2" long bolt
Rear Gate hinge
Rear Blade
Cutting Blade
26993
Shank Adjustments
DANGER
!
To avoid serious injury or death:
Make adjustments to the implement after it has been properly
attached to a tractor and secured with solid non-concrete
supports in the up position. Never work around or under
equipment supported by hydraulics. Hydraulics can drop
equipment instantly if controls are actuated or if hydraulic
lines burst even when power to hydraulics is shut off.
WARNING
!
To avoid serious injury or death:
Always keep your body extremities out from under the shanks
while adjusting them. It is possible for the shanks to fall
causing injury to your feet and/or legs.
Refer to Figure 3-1:
Shank settings are based on the vertical distance
measured from bottom edge of side plates to bottom of
shank tips. Adjust each shank height as follows:
1. Remove hairpin cotter (#1) and shank pin(#2).
2. Adjust shank (#3) up or down to the desired hole
setting and then replace shank pin and secure with
hairpin cotter.
Level and Pitch Adjustment
1. Adhere to “Shank Adjustments” safety precautions
on this page. Remove shanks located between hitch
straps and raise all other shanks fully up.
2. Locate tractor and scraper on a flat lever surface.
Lower scraper down onto the level surface, place
tractor in park, set park brake, shut tractor engine off,
and remove switch key.
3. Place a level on the longer front shank bar.
4. Manually adjust either one or both of the tractor’s
lower 3-point arms up or down to level the scraper
from left to right. Some tractors have only one arm
that is adjustable.
Shank Settings
Figure 3-1
Top Hole = 5" Below
Second Hole = 3" Below
Third Hole = 1" Below
15247