Land Pride BB1248, Руководство оператора

Страница: 10 / 20

Section 1: Assembly & Set-up
Table of Contents
9/25/18 BB1248, BB1254, BB1260, BB1266 & BB1272 Fixed Bar Box Scrapers 303-295M 6
Figure 1-1
30732
Section 1: Assembly & Set-up
1. See important note above. Attach right-hand and
left-hand hitch straps (#2 & #3) to the lower 3-Point
clevis plates with 5/8"-11 x 2" GR5 hex head cap
screws (#6), lock washers (#11), and hex nuts (#9).
Make sure the two upper holes (A & B) in the hitch
straps are in vertical alignment with lower hitch
pins (#5).
Do not tighten nuts .
2. Attach rear hitch braces (#1) to the scraper frame as
shown with 3/4"-10 x 2" GR5 hex cap screws (#6),
lock washers (#12), and hex nuts (#10).
Do not
tighten nuts .
3. With rear hitch braces (#1) positioned inside of hitch
straps (#2 & #3), 2" spacer (#4) positioned between
hitch braces (#1) and holes “A” in hitch straps aligned
with rear hitch brace holes, insert 3/4"-10 x 5" GR5
hex head cap screw (#8).
4. Secure cap screw (#8) with lock washer (#12) and
hex nut (#10). Do not tighten nut .
5. Insert 3/4" x 3 3/4" usable length clevis pin (#15)
through hitch straps (#2 & #3). If possible, secure pin
with hairpin cotter (#14).
6. When hitch is attached it will form an A-frame. Make
sure the A-frame is positioned square to the Box
Scraper frame and tighten cap screw (#8) to the
correct torque. Finish tightening hardware by
tightening cap screws (#6 & #7) to the correct torque.
7. Insert lower hitch pins (#5) through lower 3-Point
clevis plates and secure with linchpins (#13).
Tractor Requirements
Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used.
Maximum Horsepower . . . . . . . . . . . . . . . . . . 30 PTO
Hitch Type. . . . . . . . . . . . . . . . . . . . . . 3 - Point Cat. 1
WARNING
!
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator’s Manual to determine proper
weight requirements and maximum weight limitations.
Torque Requirements
Refer to “Torque Values Chart for Common Bolt Sizes”
on page 14 to determine correct torque values when
tightening hardware.
Hitch Assembly
Refer to Figure 1-1:
NOTE: Land Pride’s Quick Hitch can be attached to
the tractor to provide quick and easy 3-point hook-
up and detachment. See your nearest Land Pride
dealer to purchase a Quick-Hitch.
IMPORTANT: Hitch straps (#1& #2) must be
oriented with holes “A” in the most forward position
as shown to allow a Quick Hitch to fit correctly.