Section 1: Assembly & Setup
AFM4522 All-Flex Grooming Mower 315-360M
11/18/21
23
Hook-up LED Lights
Refer to Figure 1-14:
The lead wiring harness (#6) is equipped with a
7-way round pin connector for connecting to the tractor’s
7-pin electrical outlet shown in Figure 1-1 on page 15.
1. Route lead wire harness (#6) through spring hose
loop (#2) as shown.
2. Connect wire harness (#6) to the tractor’s 7-pin
electrical outlet.
Refer to Figure 1-15:
3. Check LED lights to make certain they are operating
correctly.
4. It is best to have a second person available for this
operation. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
5. If lights did not operate properly, recheck hook-up of
wire harness (#1, #2, & #4) to enhance module (#3).
•
Make sure connector (#1D) with a red wire is
connected to the right-hand wire harness (#1).
•
Make sure connector (#2D) with a yellow wire is
connected to the left-hand wire harness (#2).
•
Make sure connector (#3B) on the lead wire
harness (#4) is connected to connector (#3A) on
enhancer module (#3).
6. Check wire harness routing to make sure wires will
not be pinched as the decks are folded and unfolded
and while raising and lowering mower height.
7.
Add cable ties to wire harness (#1, #2, & #4) as
needed to secure them in place.
8. Continue with
IMPORTANT:
Connectors on wire harness (#1 & #2)
are labeled “Light” on one end and “Enhancer” on
the other end. Ends labeled “Light” connect to the
LED lights. Ends labeled “Enhancer” connect to
enhance module (#3).
IMPORTANT:
Connector (#1D) has a red wire and
connects to wire harness (#1) on the right side of the
implement. Connector (#2D) has a yellow wire and
connects to wire harness (#2) on the left side.
LED Hook-Up
Figure 1-14
Enhance Module Wire Connections For LED Lights
Figure 1-15
26622
70482
