Land Pride 380-152A, Руководство по установке

Страница: 4 / 14

Assembly Instructions
#380-152A & #380-336A Installation Instructions Manual No. 380-153M 7/26/22
4
Control Lever Assembly
Figure 5
Control Lever Assembly
Refer to Figure 1 on page 2 & Figure 5:
1. Remove existing knob (not shown) from end of
control lever “C”.
2. Install new control handle (#14) over end of control
lever “C” with push buttons facing operator as shown.
3. Tighten set screws (#4) against control lever “C”.
Tighten jam nuts (#5) to secure set screws (#4).
Refer to Figure 1 on page 2:
4. Reference Wire Connections “A”: Connect one
black wire in harness (#15) to one black wire in
harness (#10) and the other black wire in
harness (#15) to one white wire in harness (#10).
5. Reference Wire Connection “B”: Connect the two
red wires from the control handle (#14) to one end of
wire (#8) with fuse holder (#16). Connect opposite
end of wire (#8) to the positive (+) post on the tractor
battery.
6. Reconnect disconnected negative battery cable to
the negative (-) battery post.
Refer to Figure 3:
7. Secure wiring with cable ties (#3) as needed.
Push Buttons
15
4
14
C
3
5
37119
Bulkhead Mount shown with Pioneer Couplers
Figure 6
Bulkhead Mount Assembly
For
L2501,L3301,L3901,L3200 & L3000
Tractors
Refer to Figure 6:
1. Attach bulkhead fittings (#26) to bulkhead
mount (#1). Tighten bulkhead locknuts to bulkhead
mount.
2. When installing the kit with pioneer couplers, slide
black dust cap (#27) on bulkhead fitting (A), and
green dust plug (#30) onto bulkhead
fitting (B).
3. Attach pioneer female coupler (#24) to the bulkhead
fitting (#26B). Tighten and secure coupler to
bulkhead fitting.
4. Attach pioneer male coupler (#11) to the bulkhead
fitting (#26A). Tighten and secure coupler to
bulkhead fitting.
73083