Land Pride 315-507M, Руководство оператора

Страница: 55 / 58

Section 8: Troubleshooting
Table of Contents
AFM4211 All-Flex Grooming Mower 315-507M 3/8/23
51
Belt slipping
Plugged grooming mower Unplug and clean mower deck.
Debris in sheave Remove belt guard shields and clean sheaves.
Low belt spring tension Tighten spring take-up bolt.
Worn belt Replace belt.
Patches of uncut grass
Tractor rpm too low Mow at full throttle (540 power take-off rpm). Check
power take-off speed and tractor engine
Ground speed too fast Shift transmission to a lower gear.
Blade damaged or dull Sharpen and balance or replace blade.
Blade rotation wrong Install correct rotation blade.
Gearbox noisy
Low lubricant level Check lubricant level.
Blades scalping grass
Cutting too low Raise cutting height by adjusting wheels.
Ridges in terrain Change mowing pattern.
Fast turning speed Reduce speed on turns.
Uneven cut
Ground speed too fast Shift to a lower gear.
Mower not level Level mower.
Dull blades Sharpen blades and balance or replace.
Tractor loaded down by the
mower
Tractor rpm too low Mow at tractor’s rated power take-off rpm (540 power
take-off rpm).
Ground speed too fast Shift to a lower gear.
Grass too wet Wait until grass dries.
Grass too tall Raise cutting height of mower and cut grass twice.
Debris wrapped around mower
spindles or blades Clean mower.
Tractor power take-off
horsepower rating too low Raise cutting height of the mower and cut the grass
twice. Shift to a lower gear. Use a tractor with more
horsepower.
Blades lift too high Change to lower lift blades if they will cut the grass
satisfactorily.
Optional hydraulic
transport locks won’t
release properly
Wire ropes too long Shorten wire ropes. See
“Hydraulic Transport
Locks, Optional”
on page 26.
Optional hydraulic
transport locks won’t seat
in locking lugs properly
Wire ropes too short Lengthen wire ropes. see
“Hydraulic Transport
Locks, Optional”
on page 26.
Troubleshooting Chart
Problem Cause Solution