7
Beverage Temperature Regulator
1.
To adjust this temperature, turn the themostat knob clock
-
wise to set a lower temperature.
2. If unit has internal themostat, remove left or rear side panel
(machine with 2 compressors).
3.
To disassemble the side panels, loosen the screws on the
panels, pushing up then unlatching.
4.
To adjust temperature, turn thermostat handle clockwise to
set a lower temperature.
Every dispenser has been tested with the thermostat
set at c.a. +41
°F.
NOTE
Before adjusting temperature, always remove the power
plug.
!
ATTENTION
CLEANING AND SANITIZING
General Information
•
For health standards and quality beverages, clean as often
as possible.
•
Cleaning should be accomplished only by trained personnel.
Sanitary gloves are to be used during cleaning operations.
•
Applicable safety precautions must be observed. Instruction
warnings on the product being used must be followed.
The cleaning procedures provided herein pertain
to the Lancer equipment identified by this manual.
If other equipment is being cleaned, follow the
guidelines established by the manufacturer for that
equipment.
NOTE
Before carrying out cleanings and refills, remove the
power plug.
!
ATTENTION
Disassembling and Assembling
1. Disconnect the unit by removing the plug.
2.
Lift lid off.
3.
Pull mixer off.
4.
Lift container with both hands by a light, swinging motion
(Should you have difficulty it is necessary to dampen steel
refrigerator and gasket, then repeat the operation).
5. To remove container’s gasket, lift it from its setting.
6.
To disassemble panels unscrew the nuts on the panels,
pushing up then unlatch.
7. To reassemble the unit, repeat the above operations in
reverse.
