lancer Sensation 44, Руководство по эксплуатации

Страница: 6 / 30

6
INSTALLATION
Unpacking the Dispenser
1. Set shipping carton upright on the floor then cut package
banding straps and remove.
2. Open top of carton and remove interior packaging.
3.
Lift carton up and off of the unit.
4. Remove plywood shipping base from unit by moving unit so
that one side is off the counter top or table allowing access
to screws on the bottom of the plywood shipping base.
6. If leg kit has been provided, assemble legs by tilting unit.
If unit is to be transported, it is advisable to leave the
unit secured to the plywood shipping base.
NOTE
Inspect unit for concealed damage. If evident, notify
delivering carrier and file a claim against the same.
NOTE
5. Remove accessory kit and loose parts from ice
compartment.
Read This Manual
This manual was developed by Lancer Corporation as a reference guide for the owner/operator and installer of this dispenser. Read
this manual before installation and operation of this dispenser. See pages 17-21 for troubleshooting or service assistance. If the
service cannot be corrected please call your Service Agent or Lancer Customer Service. Always have your model and serial number
available when you call.
Selecting/Preparing a Counter Location
1. Select a level, well ventilated location that is in close
proximity to a properly grounded electrical outlet, within five
(5) feet (1.5 m) of a drain, a water supply that meets the
requirements shown in the Specifications section found on
pages 4, away from direct sunlight or overhead lighting, and
has sufficient clearance for air circulation.
2. Sufficient clearance must be provided, if an ice maker is not
installed, to allow filling ice compartment from a five gallon
bucket (a minimum of 16 inches is recommended).
Lancer does NOT recommend the use of shaved or
flake ice in the dispenser.
NOTE
4. Unit may be installed directly on counter-top or on legs. If
installed directly on the counter, unit must be sealed to the
counter-top with an FDA approved sealant. If an icemaker is
to be mounted on top of dispenser, do not install dispenser
on legs.
The dispenser should only be installed in a location
where it can be overseen by trained personnel
NOTE
1. This feature allows for flexibility between carbonated or
plain water drinks on the valves of your choice.
2. To set the adjustable back blocks, turn the shut-off stem to
the desired location, refer to the image on the right:
There is 100% flexibility on valves 4 - 9. Valves 1 - 3
and 10 - 12 are only plumbed for carbonated water
drinks and are non-adjustable. See Plumbing Diagram
on page 23 for reference.
NOTE
A B
C
A. Plain Water ON D. Water Closed
B. Carb Water ON E. Syrup Closed
C. Syrup ON
D
E
Adjusting Three-Way Adjustable Back Blocks
3. The selected location should be able to support the weight
of the dispenser, ice and possibly an icemaker being
installed after counter cut out is made. Total weight (with
icemaker) for this unit could exceed 800 pounds (363.6kg).