S4E V2 Hi-Carb Superchiller
220V / 60Hz
www.lancerbeverage.com
Page 8 of 27
Hoshizaki Lancer reserve the right to change specifications without notice
Part No: 68000006
Images are for illustration purposes only as product may vary.
012/4
– 23 April 2015
6.2
Unpacking
Caution
The use of gloves is recommended to protect hands from
potential injury from sharp edges. The Superchiller must
always be handled in a vertical position.
Carefully unpack the Lancer S4E Superchiller from the shipping carton, remove the wooden base.
If appropriate, assemble legs to unit by carefully tilting (tilt should not be more than 45°).
Inspect unit for concealed damage and if evident, notify delivering carrier and file a claim against the
carrier.
6.3
Selecting a Location
Warning
Superchillers are intended for indoor operation only; do not
operate outside unless suitably protected by a weatherproof
enclosure.
This appliance is not suitable for installation in an area where a
water jet could be used.
Superchillers are not intended to be placed on a kitchen floor.
Caution
The Superchiller is not suitable for use in subfreezing
temperatures.
To prevent damage to the water supply line, turn off and drain
unit when air temperature is below zero.
The S4E Superchiller should be located in a well-ventilated, firm, level location close to
dispenser, water and electrical supplies, with easy access for servicing
Ensure sufficient clearance around Superchiller to allow good fresh air circulation through the
condenser
– allow at least 200mm at rear and sides.
Installation should only be performed by a qualified and competent technician.
6.4
Mounting Superchiller
Install on a flat, level surface using adjustable legs or casters (Optional).
Fix to supporting
structure using 4 x ¾” BSW bolts screwed into base supports.
Caution
Superchiller operational weight is 175kg; ensure that all
supporting structures are certified for this loading by a
registered Mechanical Engineer.
Supporting structure must be securely fixed to floors or walls.
6.5
Connecting Python
Connect Python to Chiller and Dispenser.
Caution
NOTE: The S4E Superchiller is rated to operate with a maximum
of 30m of python connected.
Exceeding manufacturer’s ratings may cause damage to the
Superchiller and void warranty.
