2
CO
2
cylinders should only be handled by trained personnel who are aware of the hazards associated with CO
2
gas. CO
2
cylinders
should be handled with care. Never drag or drop a CO
2
cylinder. Never attempt to handle a leaking CO
2
cylinder. The valve should
always be closed when handling a cylinder. If the cylinder is fitted with a valve cap, always verify the cap is secure before handling.
Always store CO
2
cylinders in an upright position and in a well-ventilated area. Never store CO
2
cylinders near anything that emits
high heat and keep out of direct sunlight. Enclosed areas in which CO
2
is being stored should be equipped with a CO
2
monitoring
system.
5
CO
2
Safe Handling and Storage
Provide an adequate potable water supply. Water pipe connections and fixtures directly connected to a potable water supply
must be sized, installed, and maintained according to federal, state, and local laws. The water supply to the carbonator must be
at least a 3/8 inches (9.525 mm) pipe with a minimum of 40 psi (0.276 MPa) line pressure, but not exceeding a maximum of 80
psi (0.552 MPa). Water pressure exceeding 80 psi (0.552 MPa) must be reduced to 80 psi (0.552 MPa) with pressure regulator.
The water supply to non-carb drinks must be a minimum of 40 psi (0.276 MPa), using a water booster if needed. Use a filter in
the water line to avoid equipment damage and beverage off-taste. Check the water filter periodically, as required by local condi-
tions. The water supply must be protected by means of an air gap, a backflow prevention device or another approved method to
comply with NSF standards. A leaking inlet water check valve will allow carbonated water to flow back through the pump when it
is shut off and contaminate the water supply. Ensure the backflow prevention device complies with ASSE and local standards. It
is the responsibility of the installer to ensure compliance.
!
Water Notice
The dispenser should only be installed in a location where it can be overseen by trained personnel, and it should never be
installed in an area where a waterjet can be used.
NOTE
SPECIFICATIONS
ICDI 2200
This unit emits a sound pressure level below 65 dB.
DIMENSIONS
Width
: 15.0 inches (381 mm)
Depth
: 23 inches (584 mm)
Height
: 34.25 inches (870 mm)
COUNTER CUTOUT
Width
: 15.25 inches (387 mm)
Depth
: 23.25 inches (591 mm)
PLAIN WATER SUPPLY
Min Flowing Pressure
: 40 PSI (0.276 MPA)
Max Flowing Pressure
: 80 PSI (0.552 MPA)
CARBON DIOXIDE (CO
2
) SUPPLY
Min Pressure
: 90 PSI (0.621 MPA)
Max Pressure
: 110 PSI (0.758 MPA)
FITTINGS
Carbonated Water Inlet
: 3/8 inch barb
Plain Water Inlets
: 3/8 inch barb
Brand Syrup Inlets
: 3/8 inch barb
WEIGHT
Shipping
: 130 lbs (59 kg)
Operating (with Ice)
: 166 lbs (75 kg)
Ice Capacity
: 60 lbs (27 kg)
ELECTRICAL
Dispenser:
24 VAC, 60 Hz
Power Supply Input:
115 VAC
•
Carbon Dioxide (CO
2
) is a colorless, noncombustible gas with a light pungent odor. High percentages of CO
2
may displace
oxygen in the blood.
•
Prolonged exposure to CO
2
can be harmful. Personnel exposed to high concentrations of CO
2
gas will experience tremors
which are followed by a loss of consciousness and suffocation.
•
If a CO
2
gas leak is suspected, immediately ventilate the contaminated area before attempting to repair the leak.
•
Strict attention must be observed in the prevention of CO
2
gas leaks in the entire CO
2
and soft drink system.
5
Carbon Dioxide (CO
2
) Warning