For more Information visit
lancerworldwide.com
or call Tech Support/Warranty: 800-729-1550
6655 Lancer Boulevard
•
San Antonio, TX 78219
•
•
©2022 Lancer Corp.
•
Lancer PN: 28-0484
•
Revision 05-1, 09/14/22
Ice Cooled Drop-In
Series: 2200, 2300, 23300
Lancer
®
is a registered trademark of Lancer Corp.
ABOUT THIS GUIDE
This guide is an integral and essential part of the product and
should be handed over to the operator after the installation to
keep as a reference. Please read carefully the guidelines and
warnings contained herein as they are intended to provide the
user with essential information for the continued safe use and
maintenance of the product. In addition, it provides
GUIDANCE
ONLY
to the user on the correct services and site location of the
unit.
BEFORE GETTING STARTED
Each unit is tested under operating conditions and is thoroughly
inspected before shipment. At the time of shipment, the carri-
er accepts responsibility for the unit. Upon receiving the unit,
carefully inspect the carton for visible damage. If damage exists,
have the carrier note the damage on the freight bill and file a
claim with carrier. Responsibility for damage to the dispenser lies
with the carrier.
The installation or relocation of this product must be carried out by qualified personnel with up-to-date safety
and hygiene knowledge and practical experience, in accordance with current regulations.
FOR QUALIFIED INSTALLER ONLY.
This basic installation sheet is an initial release. If a complete operations
manual (for the unit being installed) is required or needed, please refer to the Lancer web site (lancerworldwide.
com) for immediate access, or for your convenience, scan this QR code with a mobile device (app required) for
immediate access to other Technical Documents and alternative translations (if available) pertaining to this unit.
Contact Lancer Customer Service for assistance as required.
IMPORTANT SAFETY INSTRUCTIONS
The dispenser is for indoor use only. This unit is not a toy. Children should be supervised not to play with appliance. It should not
be used by children or infirm persons without supervision. This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and
user maintenance shall not be performed by children without supervision. The min/max ambient operating temperature for the
dispenser is 40°F to 105°F (4°C to 41°C) at a max altitude of 16,400 ft (5,000 m). Do not operate unit outside these conditions.
Should freezing occur, cease operation of the unit and contact authorized service technician. Service, cleaning, and sanitizing
should be accomplished only by trained personnel. During installation, old hose sets should not be reused to connect the unit to
the water mains; new hose sets should always be used. Applicable safety precautions must be observed. Instruction warnings on
the product being used must be followed.
!
Intended Use
Check the dispenser nameplate label, located behind the splash plate, for the correct electrical requirements of unit.
Do not plug
into a wall electrical outlet unless the current shown on the serial number plate agrees with local current available. Follow all local
electrical codes when making connections. Each dispenser must have a separate electrical circuit. Do not use extension cords
with this unit. Do not ‘gang’ together with other electrical devices on the same outlet.
Do not locate multiple portable socket-out-
lets or portable power supplies at the rear of the appliance.
The key-switch does not disable the line voltage to the transformer
primary. Always disconnect electrical power to the unit to prevent personal injury before attempting any internal maintenance. The
resettable breaker switch should not be used as a substitute for unplugging the dispenser from the power source to service the
unit. Only qualified personnel should service internal components of electrical control housing. Make sure that all water lines are
tight and units are dry before making any electrical connections!
F
Electrical Warning