Lance LT-30, Руководство пользователя, Страница: 23 / 51

O P E R A T I O N P A G E 1 1
Last printed 1/31/2012 4:04:00 PM
Version Rev. 2003D-0
Direct Start Intermittent Tumbling
1. Press (RST/ENT) button on the tumbler timer.
2. Set the set-point on the tumbler timer for total tumbling time (time required for the
drum to rotate).
3. To set the time on the tumbler timer, press the (PR) button.
4. Notice the number that is flashing, press the button with the arrow pointing to right
to the desired position you want to change (the timer is set for hour/minute).
5. Press the button with the arrow pointing up to set the desired time (each position
must be done separately).
6. After the time is set, press the (RST/ENT) button to enter the time.
7. Press the (RST/ENT) again to change the current time on the timer.
8. The tumbler timer is ready to run.
9. Press (RST/ENT) button on the interval timer.
10. Set the set-point 1 "TON" for the amount of time you want the tumbler to operate
during its on cycle (the on cycle will start first).
11. To set the "TON" time on the interval timer, press the (PR) button.
12. Notice the "TON" in the lower left corner of the timer is for the on time.
13. Notice the number that is flashing. Press the button with the arrow pointing to the
right to the desired position you want to change (the timer is set for hour/minute).
14. Press the button with the arrow pointing up to set the desired on time (each
position is done separately).
15. After the time is set, press the (RST/ENT) button to enter the time.
16. Set the set-point 2 "TOFF" for the amount of time you want the tumble to rest
during its off cycle.
17. To set the "TOFF" time on the interval timer, press the (PR) button twice.
18. Notice the "TOFF" in the lower left corner of the timer is for the off time.
19. Notice the number that is flashing. Press the button with the arrow pointing to the
right to desired position you want to change (the timer is set for hour/minute).
20. Press the button with the arrow pointing up to set the desired off time (each
position is done separately).
21. After the time is set, press the (RST/ENT) button to enter the time.
22. Notice the timer will now display "TON" time.