Lance LT-30, Руководство пользователя, Страница: 20 / 51

O P E R A T I O N P A G E 8
Last printed 1/31/2012 4:04:00 PM
Version Rev. 2003D-0
Loading and Tumbling
1. Clean the machine drum.
2. Put the drain cap on the drum.
3. Load the product into the drum.
4. Place the gasket over the drum opening.
5. Place the cover on the gasket.
6. Make sure the gasket is under the cover all the way around by pushing it up and
into the opening or by visual inspection.
7. Tighten the cover by alternately tightening the knob in a diagonal pattern.
8. Plug the machine into the proper voltage receptacle.
9. Check for power to the photo-eye through observation windows (Red light should
be on. If not, wipe the photo-eye face and reflector to remove moisture.)
10. Turn on vacuum pump.
11. Open vacuum valve on the drum (next to the drum cover). Make sure the vacuum
passage to the drum is clean and that it is to the top. Pulling vacuum with the
fitting not at the top position will result in liquid being drawn into the vacuum
pump. (THIS WILL DAMAGE THE PUMP!)
12. Push vacuum hose onto drum fitting.
13. Run vacuum pump until 15 inches of vacuum is drawn. (Higher vacuum can be
drawn if desired).
14. Shut off the valve on the drum.
15. Remove the hose from the drum.
16. Turn off the vacuum pump.
17. Set the tumbler timer to the desired time.
18. Set the variable speed knob to the desired speed.
19. Make sure the vacuum hose is disconnected.
20. Press tumbler start button. The drum will now rotate until the tumbler timer runs
down to zero.
Machine can be stopped at any time by pressing the tumbler stop button or by breaking
the beam from the photo-eye to the reflector.
To restart the machine, press the tumbler start button. It will run for the time remaining
on the timer.