15
TROUBLESHOOTING
Water overflow from brew basket
•
Paper filter is not high enough and grounds are flowing over and plugging brew basket (use higher filter).
•
Coffee grounds are too fine, use courser grind of coffee.
Excessive Steam
•
Inlet water line connected to hot water supply (connect to cold water).
•
Water pressure is too low, below 15 psi (increase water pressure).
•
Spray head is plugged (remove spray head, and clean or replace).
•
Water flow is too low, confirm by running a full carafe and checking volume. If water level in carafe is low,
call for technical service.
Taste Not Acceptable
•
Quality or quantity of coffee is not high enough (purchase better quality coffee).
•
Spray head is plugged and water is boring hole in grounds (clean or replace spray head).
•
Check temperature inside of a full carafe of water. It is possible heater is not working properly.
•
Check volume of water on a full carafe setting. If it is overfilling and temperature is wrong, call for technical service.
Brewer turning on and off during cycle
•
The brewer turns heater on and off to control the water temperature. The amount depends on many factors
(inlet water temperature, water flow rate, heat wattage, supply voltage).
•
Excessive on and off will also result in excessive steam. See excessive steam for more information.
•
Clicking noise: This is temperature control and it is normal operation.
•
Brewing light flashing: IRD problem.
Water temperature cold or luke warm
•
Carafe not keeping coffee hot long enough. Pre-heat carafe by running one time without filter or coffee.
•
Check supply voltage is maybe is too low, below low 115 VAC (increase supply voltage).
•
Water flow rate too high, confirm by running 2-3 pots of water first then call for technical service.
•
Heater failed, call for technical service.
Содержание Brew Express BE-104C
Страница 2: ......