15
TROUBLESHOOTING
*Before switching ON the projector, identify and remove the causes that made the safety fuse intervene.
Call your area dealer or feel free to contact the Manufacturer for any additional assistance.
PROBLEM POSSIBLE
CAUSE
SOLUTION
No mains power supply
Make sure the mains power is ON and the circuit breaker has
not been triggered
No power to projector
Make sure the switch on the back of the projector is ON
Make sure the top lid is tightly closed
Projector does not turn
ON
Burned-out fuse
Replace the burned-out fuse* Use the type of fuse as
indicated on the side of the projector
Lamp does not ignite
Burned-out or faulty lamp
Lamp switch
Lid protection
Replace the lamp
Control lamp switch on position “On”
Lid protection is positioned correctly
An optical element is
damaged
Switch OFF the power and check lenses. If damaged call an
authorized technician.
Malfunctioning of the
electronic circuit
Contact an authorized technician
The beam is not well
defined (Faulty
projection)
The lenses are dirty
Switch OFF the power and clean the parts as explained in the
cleaning paragraph
In case of DMX control:
malfunctioning of the
DMX cable
Replace the cable and check the line before switching ON
again the projector
In case of DMX control:
wrong addressing
Check the DMX area and CONTROL ASSIGNEMENT area
and reconfigure the dip-switches correctly
Malfunctioning electronic
circuit
Contact an authorized technician
The projector does not
respond to controller
signals
Malfunctioning motor or
transmission
Contact an authorized technician
Remove the dirt and check to see if the cooling system is
working properly
Discontinuous
projector functioning
Safety thermostat has
been triggered
The fan stopped functioning. Contact authorized technician
Noisy projector
Mechanical wear
Identify the source of noise and remove the cause or contact
an authorized technician
