LaMotte Martel 5-0067, Руководство пользователя

Страница: 6 / 8

Charging the Batteries
∫ When the printer is received there may be little or no charge in batteries. The
printer should be turned off, connected to the charger, and allowed to charge
for 16 hours before the first use.
∫ The printer can remain permanently connected to the MPS power adapter to
trickle charge the batteries.
∫ To fast charge the batteries, the printer must be off.
∫ The charger cannot supply the full power requirements for the printer during
printing, so the batteries must be partially charged before printing is possible.
∫ It is recommended to connect the printer to the charger and recharge the
batteries as soon as the Status LED indicates low battery.
∫ If the batteries become exhausted, printing will become faint, erratic, or not
possible at all. Turn off the printer and recharge the batteries for at least 15
minutes before attempting further printing.
∫ The printer incorporates a low-power mode. The printer will not enter the low
power mode if the charger is attached.
Bluetooth Connection
Bluetooth Low Energy (BLE) is enabled by default.
Troubleshooting
Self Test
The self test procedure will check most of the printer functions, except for the
serial interface, i.e.: printer mechanism, control circuitry, firmware version and
print quality.
1. Turn the printer off.
2. Press and hold the Mode button for approximately 2 seconds.
3. Release the button. The printer will power on and print a self-test report.