www.howdens.com
Page _ 11
LAMONA
Appliances
Hanging Your Extractor
This instruction must be strictly adhered to. Failure to comply could result in overheating and
serious damage to your appliance. It is recommended that the installation is carried out by two people.
Before drilling or chiselling the ceiling or wall, check for pipes and power cables.
•
If ducting externally ensure the ducting tube is kept as short as possible and with the minimum
of bends to permit the smoothest
(Maximum length 3 metres.). Ducted air must not be
discharged into a
which is used for exhausting fumes from appliances supplied with energy other
than electricity. (E.g. gas boilers)
•
Ensure the requirements of the local authorities are adhered to concerning the discharge of exhaust
air.
•
Ensure adequate room ventilation is provided when the extractor is used in the same room as
appliances supplied with energy other than electricity.
•
Never duct into a hot air
such as a central heating duct
320mm
700 mm Minimum distance to worktop
750 mm Recommended distance to worktop
**
**
**
**
**
**
Worktop
Wall
73mm
(**)
Please use rawl plugs and screws appropriate
to the type of wall (not supplied)
700 mm Minimum distance to worktop
750 mm Recommended distance to worktop
40 mm
260 mm
219 mm
Please use rawl plugs and screws
appropriate to the type of wall
Wall
=
=
2
1
2
3
1. Remove the grease
before trying to install.
2. The recommended
height for the hood is 750mm above the worktop. This can be reduced to a
minimum of 700mm if required.
3. Mark and drill the holes required to mount the extractor body.
4. The principal securing points are the 2 key holes; fix this first.
is
5. With the help of an assistant, hang the extractor body on the screws level and secure in position
through the lower two .
254 mm =
=
