Exclusive to Howdens Joinery.co
Page _ 5
User manual LAM2300
Do not set your cooker hood less than
700mm above your cooker.
•
When installed between adjoining wall
cabinets, the cabinets must not overhang the
hob.
•
The edges of the cooker hood may be sharp
– be mindful of this as you handle your
appliance, especially during installation and
cleaning.
Do not clean behind the grease filter!
•
If the room where the cooker hood is to be
used contains a fuel burning appliance such
as a central heating boiler then its flue must
be of the sealed or balanced flue type.
•
If other types of flue or appliances are fitted,
ensure that there is an adequate supply of air
in the room.
•
When the hood is being used in extraction
mode, ensure that the ducting is fire retardant
and that there are no bends greater than 90
degrees as this will reduce the efficiency of
the hood.
•
Ensure the ducting for the extractor mode has
the same diameter as the outlet hole all the
way through.
•
Always put lids on pans and ensure that pans
are always on hobs when burners are lit.
•
Remember that when in extraction mode, your
cooker hood is removing air from your room.
Ensure that proper ventilation measures are
being observed.
Fire Safety
When installing the hood, ensure that the
following recommended distances are observed
between the highest point on the hob top
(including the burners) and the bottom of the
cooker hood:
Electric cookers:
700 mm
Gas cookers:
700 mm
Coal / oil cookers: 800 mm
•
Never flambé cook under this cooker hood.
•
Dirty cooking oil is an even greater fire risk.
•
Do not install above a cooker with a high level
grill.
Safety for children
•
Electrical products can be dangerous to
children. Keep children away from the product
when it is operating and do not allow them to
play with or near the product.
•
The packaging materials will be dangerous for
children. Keep the packaging materials away
from children. Please dispose of all parts of
the packaging according to environmental
standards.
Safety when working with
electricity
•
In case of any damage, switch off the product
and disconnect it from the mains. To do this,
turn off the fuse at the fuse box.
•
Make sure that fuse rating is compatible with
the product.
