www.howdens.com
Page _ 14
TROUBLESHOOTING GUIDE
Symptoms
Possible Cause
Solutions
Lamps fail to operate?
•
A replacement lamp is probably
necessary, but first check that
the lamp is correctly fitted into
its holder.
Disconnect the mains electricity supply before
adjusting or replacing the lamps.
The extractor lamps may become hot; therefore
ensure the bulb has cooled sufficiently before
replacing.
•
Power is cut.
Check if there is power. Check the fuses in the
fuse box. If necessary, replace or reset the fuses.
Motor is on but fan
does not seem to be as
efficient as usual?
•
Clogged filters can reduce the
product’s efficiency. Check the
grease and charcoal filters (if
fitted) also ensure any venting is
not obstructed?
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters
The extractor works
normaly but smells
linger?
•
Clogged filters can reduce the
product’s efficiency and may
cause unwanted smells.
Clean the grease filters with warm water and mild
detergent, and/or replace any charcoal filters.
Product does not
operate?
•
The mains fuse maybe defective
or has tripped
Check fuses in the fuse box. If necessary, replace
or reset them.
•
Product is not connected
properly.
Check all power connections.
•
If you cannot eliminate the problem after following the instructions in this section, consult your depot or the
Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Troubleshooting
Technical specification
TECHNICAL INFORMATION
Dimensions:
Extraction capacity:
220 m³/hr
Noise level min/max:
48 - 90 dB
Width :
525mm
Depth :
275mm
Height:
162 mm
Your Cooker Hood is fitted with:
Single motor 100w
Slider control operation
3 Speed extraction
x2 40W GU10 Lamps
1 Aluminium grease filter
Optional Extras:
Charcoal filter :
HJA2901 (PK2)
Ducting kits :
APL 2805/6/7
