Product emits metal noises while heating and cooling.
• When the metal parts are heated, they may expand and cause noise.
>>> This is not a fault.
Product does not operate.
• The mains fuse is defective or has tripped.
>>> Check fuses in the fuse box. If necessary, replace or
reset them.
• Product is not plugged into the (grounded) socket.
>>> Check the connection.
• If the display does not light up when you switch the hob on again.
>>> Disconnect the appliance at the
circuit breaker. Wait 20 seconds and then reconnect it.
• Overheat protection is active.
>>> Allow your hob to cool down.
• The cooking pot is not suitable.
>>> Check your pot.
" " symbol appears on the cooking zone display.
• You have not placed the pot on the active cooking zone.
>>> Check if there is a pot on the cooking zone.
• Your pot is not compatible with induction cooking.
>>> Check if your cooking pot is compatible with
induction hob.
• The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the
cooking zone.
>>> Choose a pot wide enough and center the pot on the cooking zone properly.
• Cooking pot or cooking zone is overheated.
>>> Allow them to cool down.
Selected cooking zone suddenly turns off during operation.
• Cooking time for the selected cooking zone may be over.
>>> You may set a new cooking time or finish
cooking.
• Overheat protection is active.
>>> Allow your hob to cool down.
• An object may be covering the touch control panel.
>>> Remove the object on the panel.
The pot does not get warm even if the cooking zone is on.
• Your pot is not compatible with induction cooking.
>>> Check if your cooking pot is compatible with
induction hob.
• The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the
cooking zone.
>>> Choose a pot wide enough and center the pot on the cooking zone properly.
Touch control does not respond.
•
Sensor is not calibrated correctly.
>>> Disconnect the appliance at the circuit breaker, wait 20
seconds and reconnect it (sensors will auto calibrate).
Condensation is not a product fault
Troubleshooting
21
User manual LAM1802
