Disabling the timers:
First you must display the timer by changing the
position of the key until the timer appears.
This value can later be cancelled in 2 different ways:
• By decreasing the value step by step to
00
by touching key.
• By touching " " and " " keys simultaneously for
half second until "00" appears on timer dis-play.
When the time is over, an audible alarm will
sound. Touch any key on the touch control panel
to silence the audible alarm.Display the remaining
time value of the cookingzone timer 3 (indicator
LED flashes) to the timer display (the indicator
LEDs of the active timers of the cooking zones 1
and 4 in fact will not be visible on the timer display).
Sensor calibration and error messages
When the supply power is applied, hob control
system performs calibration depending on the
sensor, glass and ambient conditions. Do not
cover the glass part of the sensor with anything
during calibration. Hob control system should
also not be exposed to strong light sources such
as sun light, strong halogen lamps and etc.
Table 3: Error codes and error sources
Following lighting conditions will allow a smooth
calibration: Illumination with a bulb without a
reflector (100W, dull) 70 cm above the glass
ceramic hob. After a success-ful calibration, it is
warranted that the hob will operate as intended
even under a strong illumination such as halogen
spot lamp with reflector (50 W). In case of an error,
turn the power supply off and turn back on again.
When the time is over, an audible alarm will
sound. Touch any key on the touch control panel
to silence the audible alarm.
Cooking zone timer:
The cooking zone timers cay only be set for the
cooking zones that are activated.
1. First turn on the hob and then enable the
desired cooking zone. (cooking zone must be set
to a value between
1
and
9
)
2. As in the alarm timer, enable the cooking
zone timer by touching key.
00
and will
appear on the timer display and a dot will appear
on the lower right side. Thus, cooking zone timer
is activated.
3. You must touch key for a second time in
order to enable cooking zone timer. Now you can
assign the timer.
4. Set the desired time value by touching
and keys.
To set the hob timers:
1. After enabling the first cooking zone timer,
touch the key again. The control will turn
clockwise towards the next active cooking zone
assigned to the timer. Assignment proposal will
be shown with a flashing LED.
2. Set the desired time value by touching
and keys.
3. Timer activated for the cooking zone which
was set first is indicated with a continuously
flashing LED.
• More timers can be assigned for other active
cooking zones by touching the key once again.
• After 10 seconds, timer display reverts back
to the timer that will end first.
• LEDs that illuminate continuously on the
timer display indicate the timer that is currently
counting down.
• You can display the values set for cooking
zone timers and egg timer by changing the
position of key. A flashing front right LED
always shows an assignment.
If no LED is flashing, value of the egg timer will
be displayed on the timer screen.
(x=”0...9”)
Cause of error
Display
Ambient light is too high
F1
F2
F3
F4
AX
EX
Fluorescent lamp
Ambient light is fluctuating strongly
Calibration
Induction hardware error
Sensor is covered with a
bright subtance
13
User manual LAM1802
