repeat the process explained above. It is possible
to set the timer to both of the cooking zones
simultaneously. If it is set the timer to both cooking
zones, the lower timer value appears on the timer
display.
Timer cannot be set without selecting the
cooking zone.
If the timer is not selected before the 10
seconds, the timer is switched off. If the selected
time is
“00”
after 10 seconds the timer is switched
off.
Changing the timer
When the timer is in countdown the use can
change the time at any time by touching the timer
key, the countdown stops and the timer changes
to the time selection status waiting a time selection.
Deactivating the timers early
If you deactivate the timer earlier, the hob will keep
on operating at the set temperature until it is
switched off. You can deactivate the timer earlier in
two different ways:
Deactivating the timer for related zone by
dropping its value to “00”.
1.
Touch the timer key until the
“00”
appears
on the display of the cooking zone whose timer is
active.
The timer will be cancelled and the temperature
level reduced to
“0”
of the related zone.
Operation time limits
The hob control is equipped with an operation time
limit. If one or more cooking zones are left on, the
cooking zone will automatically be deactivated after
a certain period of time (see table below). If there
is a timer assigned to the cooking zone, the timer
display will also turn off later.
Operation time limit depends on the selected
temperature level. Maximum operation time is
applied at this temperature level.
The cooking zone may be reactivated by the user
after it is switched off automatically as described
above.
Temperature Level
0
1
1
1
2
2
2
2
3
3
4
4
5
6
7
8
9
Rapid Heating (P)
0
10
5
5
Operation Time
Limit Hour
Overheating protection
Your hob is equipped with sensors which provide
protection against overheating. Following may
be observed in the case of overheating:
• Operating cooking zone may get switched off.
• Selected level may drop. However, this condition
cannot be seen on the indicator.
Error Messages
_ 11
Display
Cause Of The Error
Touch control software error
F0
Fc
Ft/FE
Fb
FU/Fj
Touch control temperature sensor
can be damaged
Excessive sensitivity on any key
Security keyboard error
Touch control zone is too hot
and has turned off all heaters
User manual LAM1749
