Depending on your product, the images below represents how the system interacts with your worktop.
Note;
The worktop cut out dimensions are critical and will affect the performance of how the push fit
system works. The nominal dimensions are shown on the hob cut out table and must be fabricated to a
tolerance of +2.0mm -0.0mm. The effectiveness of the system will vary depending on the accuracy of
the worktop cut-out dimensions.
The hob seal and wiring must be completed prior to fitting the hob into the worktop. Offer the back edge
of the appliance up to the rear of the worktop cut-out keeping the hob central to the cut-out. Care must
be taken not to trap the power cable between the hob & the worktop cut-out.
Ensuring nothing is misaligned or trapped, using both hands press down evenly on the front of the hob
until it sits in its home position. When doing this, make sure that the seal under the hob sits flush with
the worktop on all sides. This is important to ensure an effective seal all around the product. The hob
can be removed by applying a small amount of pressure to the underside of the hob.
Note; If your worktop cutout is oversized, an optional fitting kit can be purchased from our
Spares Store.
