English
Application Tanga Delta S2
The Lamello Tanga Delta S2 is ideal for the for the window
replacement. Ideal for cutting out the old window frames by
cutting into the wall.
It can be use for the following tasks:
When working with the diamond blade
– To remove old window frameworks
– To cut building materials such as finery, brick, tiles,
lime sandstone, artificial marble, granite, concrete, as
well as their metal fixations. (Total maximum cutting
surface of metal fixations must not exceed 50 mm2)
When working with the carbide wood blade
– Removing of old window frames without taking off
the window sills
– Cutting wood materials such as soid wood, plywood,
chipboard, fibre board as well as various plastic materials
– Shortening doors and cutting of wood covers
– Cutting of expansion gaps (gap width 7mm)
– Making cuts into walls and ceiling for ventilation
openings etc.
– Roofing apertures or cutting to length of roof battens
The use of the machine is limited to the specified
materials. All instructions regarding use and maintenance
are to be strictly complied to.
Instruction of use
Connect a high performance vacuum cleaner; clean filters frequently!
The diagonal front (45°) must be used only with the diamond blade (not with the wood blade)
1. Use eye and ear protection
2. Set the depth adjuster to the correct blade diameter (turn to 180 or 200 mm)
3. Adjust the desired cutting depth by shifting the stop sleeve (stepless)
4. Set machine onto the work-piece. Apply the machine securety.
5. Start the machine, immerse and push forward in the direction of rotation with light pressure (Careful: Do not
overload the engine!)
When cutting with the Diamond blade, please observe
the following:
– Working pressure = weight of the machine
– Keep cutting blade in a right angle to the working material
– Do not twist the blade
– Allow the machine to cool down from time to time (Let
the machine run free)
– When mounting the blade consider direction of rotation
as marked on the blade
Change from straight front to 45° front (for cutting
into the corner)
1. Disconnect machine from power supply
2. Open quick-locking mechanism and lock, (pull button
and lock the counterclockwise)
3. Remove bottom plate by pulling forward
4. Attach bottom plate with 45° corners
5. Close quick-locking mechanism
Change from 45° front to straight front
1. Disconnect machine from power supply
2. Open quick-locking mechanism and lock, (pull button
and lock the counterclockwise)
3. Remove bottom plate by pulling forward
4. Attach square bottom plate
5. Close quick-locking mechanism
Changing of tool
1. Disconnect machine from power supply
2. Open quick-locking mechanism
3. Remove bottom plate by pulling forward
4. Press spindle stop, un-tighten the 4 countersunk
screws with a screw driver; change blade (consider
direction of rotation!); re-tighten the 4 screws
5. Attach square bottom plate
6. Adjust the depth adjuster to correct blade diameter
(turn to 180 or 200 mm)
7. Let the machine run free at maximum speed for at
least 30 seconds to test correct mounting of the tool
Please note
– The machine is supplied ready for use.
– The saw emerges from the machine housing only
during actual operation.
– Overload protection: This machine is equipped with a
power overload protection.
