Lamborghini Caloreclima LMB LO 1300, Руководство по эксплуатации и обслуживанию

Страница: 51 / 84

51
GB
APPLIANCE
Main features
- EMC filter on the board;
- Protection fuse on the board;
- Stable timers not affected by the voltage and/or temperature changes (system management by microprocessor);
- protection in case of low voltage power supply;
- protection in case of high power supply voltage;
- non-volatile block;- intermittent functioning: regulation and self-diagnosis stop every 24h;
- air damper control for functioning at several stages or modulating;
- independent control outputs for 3 fuel valves;
- remote reset;
- built-in button or two-colour LED for indicating functioning status and anomalies;
- flame detection via photoresistence;
Signals
FunCtiOninG MODes
Status Colour Signalling mode
OFF O
ff
s
tANd By
G
reeN
(
flAshiNG
) V (-) V (-) V (-) V (-) V (-)
P
re
-
VeNtilAtiON
y
ellOw
(
flAshiNG
) G (-) G (-) G (-) G (-) G (-)
s
Afety tiMe
(
flAMe siGNAl NOt PreseNt
G
reeN
(
flAshiNG
) V (-) V (-) V (-) V (-) V (-)
s
Afety tiMe
(
flAMe siGNAl PreseNt
)
G
reeN
f
ixed
B
urNer ON
G
reeN
(*) f
ixed
P
Ost
-
VeNtilAtiON
(
with BurNer iN BlOCk
)
G
reeN
– y
ellOw
V , G , V , G , V , G , V , G
BLOCKs AnD AnOMALies
Status Colour Signalling mode
Parasite flame O
ff
Undervoltage-Overvoltage G
reeN
(
flAshiNG
) V (-) V (-) V (-) V (-) V (-)
No ignition blockAppliance ano-
maly block
y
ellOw
(
flAshiNG
) G (-) G (-) G (-) G (-) G (-)
Parasite flame block r
ed
(
flAshiNG
) r (-) r (-) r (-) r (-) r (-)
Block due to servo-motor ano -
maly
r
ed
(
flAshiNG
) r (-) r (-) r (-) r (-) r (-)
Block due to flame switch-off r
ed
(
fAst flAshiNG
) r (-) r (-) r (-) r (-) r (-)
speCiAL FunCtiOns
Status Colour Signalling mode
Temporary shutdown y
ellOw
(f
Ast flAshiNG
) G (-) G (-) G (-) G (-) G (-)
Pump engagement G
reeN
, y
ellOw
, r
ed
V, G, r, V, G, r, V, G, r,
Key (-) = Off V = Green G = Yellow R = Red
M
(*) If the value of the flame detected exceeds the threshold value by 5 times (threshold=3.5 lux) the signal remains GREEN
fixed light.
If this is not the case, the signal will be flashing GREEN, with number of flashings linked to the value of the flame detected
(number of flashing = flame signal lux/flame detection threshold lux).