LAMAX eTiger ATV50S BLUE, Руководство пользователя

Страница: 20 / 150

14
EN
CS
CS
CZ
CZ
CZ
CZ
CZ
TYRE PRESSURE
–
Check the tyre pressure (170 kPa / 24 PSI) and the condition of the tread regularly. Always perform tyre
pressure and any inflation when cold. In the event of a flat tire and the need to replace the wheel rim,
contact the service department.
CONTROLS
The quad bike is operated by using hands only.
RIGHT HANDLEBAR SIDE
–
Grip / Throttle – the right grip controls the speed.
–
FORWARD/REVERSE/OFF– switch to change the direction of travel.
–
Right front disc brake lever – use the lever to brake the front wheel.
–
Battery charge indicator – 4 bars (fully charged), 3 bars (sufficiently charged), 2 bars (low), 1 bar (dischar-
ged)
LEFT HANDLEBAR SIDE
–
Grip
–
Switch (red) – turns the front headlight on/off.
–
Switch (green) – controls the horn.
–
Left rear disc brake lever – use the lever to brake the rear axle.
CHARGING SOCKET
–
The charging connector can be found under the cover on the left side under the handlebars.
SPEED SWITCH
–
A 3-position switch with a key is located on the left side of the motor
cover. This switch can be used to adjust the maximum speed.
–
L: Low speed – (6 km/h)
–
M: Medium speed – (15 km/h)
–
H: High speed – (25 km/h)
OPERATION
–
Insert the key into the ignition switch located below the battery indicator on the right side of the han-
dlebars.
–
Set the direction switch to the FORWARD or REVERSE position depending on which direction you want
to go.
ATTENTION
Never flip the switch while the vehicle is in motion.
–
Carefully twist the accelerator (throttle) grip towards you and the quad bike will start moving.
–
Stop by releasing the throttle grip.
–
Use the brake levers to stop immediately – right for the front brake, and left for the rear brake.
–
When the brake lever is pressed, the motor is automatically disengaged until the brake levers are
released again.
–
The wheels may „throw“ slightly at higher speeds.