Select Hand ~ Fit bottom trims
Select ‘hand’ for unit build. Trim
is
fi
tted at base only.
Apply a continuous bead of silicone along inside of trim then
carefully
push trims fully onto bottom edge of glass panel.
B
utt trim up to vertical pro
fi
le. Do not bend or
strike with hard objects,
a soft mallet or hammer & wooden block should be used if necessary.
Typical Wall Panel Construction :
Typical extended Panel Construction :
B
`
1.
Press / clip extension pro
fi
le onto wall pro
fi
le.
2.
Locate panel sub assembly onto extension pro
fi
le &
push fully back.
3.
Check panel length is as required (panel may be
pulled away from wall pro
fi
les by 15mm).
4.
Ensure panel is plumb, carefully drill (dia 3mm) &
screw panel to extension pro
fi
le.
1. Locate panel sub assembly onto extension profile & push fully
back.
2. Check panel length is as required (panel may be pulled away from
wall profiles by 15mm).
3. Ensure panel is plumb, carefully drill (dia 3mm) & screw panel to
extension profile.
