UNPACKING AND OPERATING INSTRUCTIONS
In order to operate your LakeAir Air Cleaner properly, it is necessary to remove plastic packing material from the carbon
afterfilter inside the unit. Follow the step–by–step instructions and you will soon be enjoying clean fresh air.
1.
Remove the two fasteners from the top of the
cabinet using a Phillips head screwdriver.
2.
Lift the cover assembly from the chassis and set
aside.
3.
Remove the carbon afterfilter from behind the
cell. Take off the protective packing material and
discard.
4.
Replace the carbon after filter, then the cover
assembly, making sure to include both of the fasteners. NOTE: The fasteners must be in place
and secured snugly or the unit
will not operate.
Place your LakeAir Air Cleaner in a convenient area in the desired room. If you are using the air cleaner for a specific
purpose, such as smoke removal, locate the air cleaner as close as possi-ble to the source. (Such as near a smoking stand.) Care
should be taken to allow at least 4-6” of unobstructed space behind the unit so that it will exhaust freely into the room. If,
however, you position the unit so that the airflow is parallel to the nearest wall, you need not allow as much free space. For
best results the unit should be elevated by placing it on a table or stand. It can also be mounted on a wall, using our
convenient wall mount option.
Plug the line cord into a standard household outlet with 120V AC 60 Hz (230 models require 230 V AC 50 Hz). Caution
should be taken to use the unit only on the required voltage, as to do otherwise will void the warranty.
OPERATING AND MAINTE-NANCE
INSTRUCTIONS
Position the unit and plug it into the proper line voltage before
turning it on.
1.
To turn unit on, locate the three-position
rocker switch
on top of the unit. Depress the
button to activate the unit on the desired speed;
High, Low,
or
Off
(center, flat position). Under
normal conditions, the
Low
position is adequate
to keep an average size room clean. With
exces-sive amounts of dust, smoke, or other pollutants
present,
the air cleaner should be operated on
high.
2.
To shut the unit off, simply push the
button to its
center (flat) position and
unplug the unit from the line
voltage.
NOTE: It should be noted that occasion-ally a large
particle will pass through the electronic cell and an
arcing will occur, resulting in an audible cracking
sound. This is normal and will not cause any damage
to the unit.
4
