Laizhou Huibang Machinery MS36127A3, Руководство по эксплуатации для владельца

Страница: 9 / 15

6. Insert bar (F) Fig. 7, into hole on top of fence as shown, and tighten set screw (G) against flat on bar (F).
7. Assemble the holddown (H) Fig. 7, onto bar (F) as shown, and tighten set screw (J) against flat on bar.
TOOL AND CHISEL HOLDER
1. Assemble tool and chisel holder (A) Fig. 8, to side of column using the two M6x1x25mm screws (B) and M6 flat
washers as shown.
2. Illustrates the chuck key, wrench and chisels and bits in holes of tool and chisel holder (A) when not in use.
Fig 8
OPERATING CONTROLS AND ADJUSTMENTS
RAISING AND LOWERING THE HEAD
The head (A) Fig. 9, is raised and lowered by means of the lever (B). For maximum leverage during the mortising
operation, the lever (B) can be repositioned by pulling out the hub (C) of the lever assembly and repositioning hub on the
pinion shaft.
Fig 9 Fig10