38
39
English
Instructions and guarantee
GB
GB
English
WRIST BLOOD PRESSURE MONITOR
knocks, dust and direct sunlight.
Do not drop or hit the unit.
• Clean the unit using a soft, dry cloth only. Do not use any chemical or abrasive products to clean the
monitor.
Ensure that no liquids enter the appliance.
• Do not press the “ON/OFF” key if the armlet is not wrapped around the arm.
•
This appliance is not waterproof.
• Place the device in the supplied case and, to store it, observe the environmental conditions stated here
below.
SPECIAL CASES
If the following circumstances occur:
1) After pressing the “ON/OFF” key the reading does not start.
• Check that the keylock switch is set to “ON”.
• Check the batteries and replace them if needed
• Clean the contacts of the batteries with a dry cloth.
2) Nothing appears on the display when the “MEM” key is pressed.
• The batteries are flat.
3) The batteries do not last long.
• Use alkaline batteries to increase working autonomy. If normal zinc-carbon batteries are used they will
need changing more often.
4) You cannot complete a reading.
• Check the batteries and change them if needed.
5) The blood pressure levels are different with each reading - the readings are very low or very high.
• The measuring position is not correct
Read the paragraph “Correct measuring position” again.
• The blood pressure readings vary constantly depending on the time of day and the state of nerves of
the person.
Read the paragraphs “Warnings” and “Important” again.
6) The heart beat readings are too high or too low:
• The person moved while the reading was being taken.
• The reading was taken after physical exertion.
Read the paraghaphs “CORRECT MEASURING METHOD”, “WARNINGS” and “IMPORTANT”again.
7) On the display, appears the symbol
.
• It has been detected the presence of an irregular pulse (arrhythmias).
Repeat the measurement.
If the symbol
appears again, refer to a physician to
establish the most suitable treatment to be followed
.
COMPONENTS
1) LCD DISPLAY
2) “ON/OFF” KEY
3) “MEM” KEY
4) “KEYLOCK” SWITCH
5) ARMBAND
6) BATTERY COMPARTMENT
7) BATTERIES
8) CASE
TECHNICAL FEATURES
• Pressure indication range:
between 0 and 300 mmHg (arm cuff pressure)
between 40 and 180 pulsations/min. (pulse frequency)
• Precision:
±3 mmHg (arm cuff pressure)
± 5% of the read value (pulse frequency)
• Inflating and deflating:
automatic
• Power supply:
2 alkaline batteries 1,5V type AAA (LR03)
• Memories:
60 Memories
• Working conditions:
b5°C and +40°C; 90% relative humidity or lower
• Storage conditions:
between -20°C and +55°C; 90% relative humidity or lower
• Atmospheric Pressure:
80kPa – 105 kPa
• Wrist circumference:
between 140 and 195 mm approx.
• Battery life:
about 180 readings
• Dimensions:
90x80x30 mm