laguna SHEARTEC II PX-22, Руководство пользователя

Страница: 14 / 83

PX-22 SHEARTEC II PLANER 14
If this information is different than what is stated on the Motor Specification Plate - omit this information. It is
possible that the documentation is outdated to a machine change - such as a different motor. Always check the
motor plate prior to any wiring. If any doubts, please consult a certified electrician. Know when to use a time delay
fuse! AKA Slow blow fuse. Generally, if the motor uses a start capacitor, a time delay fuse is required. This type of
fuse (circuit breaker) will not trip with the initial amperage needed to start the machine, which is typically double
that of the running amperage. Most woodworking machines use this type of fuse.
**NOTICE!**
Electrical Safety- Electrical Cord and Plug is not provided with Ordered Machine. Make
sure to have a Qualified Electrician install required a qualified/standardized electrical cord and plug for
purchased machine. *Electrical Code that must be met in your local state (USA) or province (CSA). An
electrician will verify that all the demands are met to properly wire the machine. If you have absolutely
any doubt when wiring this machine - please consult with a Qualified Electrician.
Electrical Safety (Cont’d.)- A Electrical Cord and Plug is not provided with Ordered Machine. Make sure
to follow Electrical Installation stated in the instructions below.
*Electrical Code that must be met in your local state (USA) or province (CSA).
Grounding Methods:
Electrical Cord and Plug is not provided with Ordered Machine. When a proper qualified electrical cord
and plug is installed please follow the following ground methods and procedures.
Grounding Methods Provided by CSA Group.
Fig. (A) Receptacle with nominal rating less than 120 volts.
Fig. (B) 150 Volt receptacle without grounding pin fitted with adapter.
Fig. (C) 150-250 Volt receptacle.