laguna Quadtec I PXI12, Руководство пользователя

Страница: 19 / 36

19 PX|12 Quadtec:I Planer \ Setup Assembling
Figure 3: Thickness Adjustment Handle
2. Clean all rust protected surfaces with a commercial de-greaser. DO NOT use acetone, gasoline, lacquer
thinner or any type of cleaner that could damage paint. Coat cleaned surfaces with WD-40® or 20W
machine oil.
3. Install dust chute using the included hardware to mount to the outfeed side of planer. 3 screws, one on
each side and one underneath the dust chute.
4. Attach dust collector to dust chute.
NOTICE!
MAKE SURE THE DUST COLLECTION SYSTEM HAS SUFFICIENT CAPACITY AND CFM FOR THIS PLANER. ALWAYS TURN
ON THE DUST COLLECTOR BEFORE PLANNING.
Power Supply
Power Supply Circuit Requirements
The power source circuit for your machine must be grounded and rated for the amperage given below.
Never replace a circuit breaker on an existing circuit with one of higher amperage without consulting a
qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in
your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.
Circuit Size (110V, Single Phase) ........20 Amp (minimum)