laguna MPLANPX12-0130, Руководство пользователя

Страница: 23 / 36

23 PX|12 Quadtec:I Planer \ Maintenance
Maintenance
General
Keep your machine clean. At the end of each day, clean the machine. Wood contains moisture, and if
sawdust or wood chips are not removed they will cause rust.
In general, we recommend that you only use a Teflon-based lubricant on the planer. Regular oil attracts
dust and dirt. Teflon lubricant tends to dry and has less of a tendency to accumulate dirt and sawdust.
Periodically check that all nuts and bolts are tight.
Routine Inspections
It is a good idea to routinely inspect any quality woodworking tool in order to keep it in optimum condition.
This includes inspecting all hardware for tightness, ensuring the filter is clean, and cleaning debris and
grime from any surfaces and moving parts. In addition, make sure to:
·
Clean out-feed rollers and table with a non- flammable solvent to remove pitch, gum and other
unwanted build-up.
·
Periodically clean the inside of the machine for dust control.
·
Keep pulleys and belts free from dirt, dust, oil and grease.
·
Replace worn belts as needed.
·
Replace or rotate worn knives.
Knife rotation/replacement
CAUTION!
KNIFE INSERTS ARE DANGEROUSLY SHARP. USE EXTREME CAUTION WHEN INSPECTING, REMOVING, OR REPLACING
KNIFE INSERTS.
WARNING
·
TURN PLANER OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
·
MAKE SURE ALL KNIFE INSERT SCREWS ARE TIGHTENED SECURELY. LOOSE INSERTS CAN BE PROPELLED AT HIGH
SPEED FROM A ROTATING CUTTERHEAD, CAUSING INJURY.
TORQUE EACH SCREW TO 52-60 IN/LBS.
NOTICE!
·
THE DUST CHUTE AND CHIP DEFLECTOR MUST BE REMOVED TO ACCESS CUTTERHEAD. REMOVE THE THREE
SCREWS ATTACHING THE DUST CHUTE AND REMOVE. REMOVE THE TWO SCREWS SECURING THE CHIP
DEFLECTOR AND REMOVE.
·
WHEN CHANGING KNIFE INSERTS IT MAY BE NECESSARY TO ROTATE THE CUTTERHEAD TO A NEW LOCATION.
DEPRESS THE AUTO LOCK (FIG. 15) ON THE RIGHT SIDE WHILE ROTATING CUTTERHEAD WITH A TORX WRENCH IN
ONE OF THE SCREW HEADS OR A PIECE OF WOOD.