laguna MPLANPX12-0130, Руководство пользователя

Страница: 21 / 36

21 PX|12 Quadtec:I Planer \ Setup Assembling
7. Repeat Step 5 until the planer removes the entire top surface of the calibrating board. NOTICE! Drawing
pencil marks across the width of the top of the calibrating board in several locations can make it easier
to determine when the entire surface has been planned.
8. Measure the thickness of the calibrating board with a caliper.
9. Loosen the two screws of the Thickness Scale pointer and adjust the pointer (Fig. 7) until it corresponds
to the measured thickness and tighten the screws.
Setting Extension Tables
There are two extension tables, one on the infeed and one on the outfeed side of the planer (Fig. 11).
1. Lower both extension tables.
2. Place a straight edge on the bed of the planer and extend over the extension table. The outside “end” of
each extension table should be level with the bed. It is okay for the inner section of the extension tables
to be lower than the main bed. The extension tables should never be higher than the main bed under
the cutterhead.
3. If adjustment is needed, raise the extension table requiring adjustment.
4. Loosen the lock nut at the bottom of each bolt. Adjust the two hex head bolts on each side of the
extension table either up or down and check alignment. Make only small adjustments.
5. When the tables align properly tighten the two lock nuts at the bottom of each bolt.
Operation
CAUTION!
PLACE THE PLANER ON A SECURE AND STABLE SURFACE FOR OPERATION. CLAMP OR BOLT THE PLANER INTO
POSITION.
1. Lower each extension table to support stock.