8
SHEAR-TEC II Cutterhead
Knife inserts are dangerously
sharp. Use extreme caution when inspecting,
removing, or replacing knife inserts.
The knife inserts on the Jointer are four-sided.
When dull, simply remove each insert, rotate it 90°
for a fresh edge, and re-install it. No further
adjustment is necessary. Use the two provided
torx
wrench
to remove the knife insert screw. Use one
of the torx wrenches to help hold the cutterhead in
position, and the other to remove the screw. See
Fig. A. It is advisable to rotate all inserts at the
same time to maintain consistent cutting. However,
if one or more knife inserts develops a nick, rotate
only those inserts that are affected.
Each knife insert has an etched reference mark so
you can keep track of the rotations.
IMPORTANT: When removing or rotating inserts,
clean saw dust from the screw, the insert, and the
cutterhead platform. Dust accumulation between
these elements can prevent the insert from seating
properly, and may affect the quality of the cut.
Before installing each screw, lightly coat the screw
threads with machine oil and wipe off any excess.
Securely tighten each screw which holds the knife
inserts before operating the jointer!
Make sure all knife insert screws are tightened
securely. Loose inserts can be propelled at high
speed from a rotating cutterhead, causing injury.
Fig. A
Cutterhead Removal
If removal of the cutterhead is necessary, do the
following:
WARNING: Disconnect jointer from power
source.
1. Remove the entire fence assembly by releasing
lock handle and removing hex nuts. Lift the
fence off the machine.
2.
Loosen the bolts connecting the motor to the
motor mount and remove the drive belt from
cutterhead pulley.
3. Lower
both
infeed
and
outfeed
tables
to
expose
the
cutterhead.
4. Remove
the
two
bolts
and
spring
washers
which
secure
the
cutterhead
to
the
base,
as
shown
in
Fig. B.
5. Remove
the
cutterhead
as sembly,
with
studs
attached,
by
lifting
cutterhead
straight
up
from
base.
The
belt
pulley
may
be
left
on
cutterhead
to
assist
in
raising
the
cutterhead.
6. Remove
pulley
and
both
bearing
housings
with
attached
studs
from
the
cutterhead.
NOTE:
You
may
wish
to
keep
on
hand
an
extra
cutterhead
in
order
to
maintain
shop
productivity.
7. When
mounting
new
cutterhead
to
base,
make
sure
the
curved
seats
of
the
base
are
cleaned
and
free of
dust
and
grease.
Fig B
！
Содержание MJOIN12X86-5-1-0130
Страница 20: ...19 PARTS DIAGRAMS ...
Страница 21: ...20 ...
Страница 22: ...21 ...
Страница 23: ...22 ...
