laguna MJOIN12X86-5-1-0130, Руководство пользователя

Страница: 15 / 29

14
Basic Operations
Before m aking any c uts on t he s tock, m ake a f ew
practice cuts by r aising t he i nfeed t able to “ 0" a nd
with the power disconnected. In this manner you will
acquaint yourself with the feel of jointer operations.
SURFACING
two handed push
block
Adjust depth of cut. It is better to make cuts of ap-
proximately 1/64 inch. This will enable you to hav e
better control over the material being surfaced. Make
several passes if necessary to obtain proper stock
removal.
Never surface pieces shorter than 12 inches or thin-
ner than 3/8 inch without the use of a special work
holding fixture. Never surface pieces thinner than 3
inches without the use of a push block. On stock 8"
to 12" long use a single two-handed push block (Fig.
18). On stock longer than 12 inches use two push
blocks ( Fig. 19). With narrow stock use the type
push block shown in Fig. 20. When surfacing short
stock over 4 inches wide, use two (2) push blocks to
guide material over cutterhead (Fig. 21).
L-shaped push block
for narrow stock
two push blocks
for stock longer
than 12 inches
Fig. 18
Fig. 19
two push blocks
with dowels
for short stock
over 4 inches wide
Fig. 20
Fig. 21