laguna Fusion F3, Руководство пользователя

Страница: 7 / 68

Fusion F3 Table Saw - Safety - 7
© 2020 Laguna Tools
KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from work area.
DISCONNECT UNIT before servicing.
CHECK DAMAGED PARTS. Before further use of the unit, properly repair or replace any part that is damaged.
CSA Required Safety Information
For Your Own Safety Read Instruction Manual before Operating Tablesaw.
a) Never place your hands in the vicinity or in line with the saw blade.
b) "Wear eye protection" or the sign M004 of ISO 7010.
c) Always use a properly functioning saw-blade guard, riving knife and anti-kickback device for every
operation for which it can be used, including all through sawing.
d) Use a push-stick or push-block when required.
e) Do not perform any operation freehand.
f) Pay particular attention to instructions on reducing risk of kickback.
g) Never reach around or over saw blade.
h) Turn off tool and wait for saw blade to stop before moving workpiece or changing settings.
i) Never stand directly in line with the saw blade. Always position your body on the same side of the saw
blade as the fence.
In addition, use hearing protection and wear gloves when handling saw blades.
Guarding Related Warnings
a) Keep guards in place. Guards must be in working order and be properly mounted. A guard that is loose,
damaged, or is not functioning correctly must be repaired or replaced.
b) Always use saw blade guard, riving knife and anti-kickback device for every through-cutting operation. For
through-cutting operations where the saw blade cuts completely through the thickness of the workpiece, the guard and
other safety devices help reduce the risk of injury.
c) Immediately reattach the guarding system after completing an operation (such as rabbeting, dadoing or
resawing cuts) which requires removal of the guard, riving knife and/or anti-kickback device. The guard, riving knife,
and anti-kickback device help to reduce the risk of injury.
d) Make sure the saw blade is not contacting the guard, riving knife or the workpiece before the switch is
turned on. Inadvertent contact of these items with the saw blade could cause a hazardous condition.
e) Adjust the riving knife as described in this instruction manual. Incorrect spacing, positioning and
alignment can make the riving knife ineffective in reducing the likelihood of kickback.
f) For the riving knife and anti-kickback device to work, they must be engaged in the workpiece. The riving
knife and anti-kickback device are ineffective when cutting workpieces that are too short to be engaged with the riving
knife and anti-kickback device. Under these conditions a kickback cannot be prevented by the riving knife and
antikickback device.
g) Use the appropriate saw blade for the riving knife. For the riving knife to function properly, the saw blade
diameter must match the appropriate riving knife and the body of the saw blade must be thinner than the thickness of
the riving knife and the cutting width of the saw blade must be wider than the thickness of the riving knife.
Cutting Procedures Warnings
a) Never place your fingers or hands in the vicinity or in line with the saw blade. A moment of inattention or a
slip could direct your hand towards the saw blade and result in serious personal injury.
b) Feed the workpiece into the saw blade or cutter only against the direction of rotation. Feeding the
workpiece in the same direction that the saw blade is rotating above the table may result in the workpiece, and your
hand, being pulled into the saw blade.