laguna Fusion F3, Руководство пользователя

Страница: 27 / 68

Fusion F3 Table Saw - Setup - Front Rail 27
© 2020 Laguna Tools
You may assemble both right extension legs at this step, though only one will be used to complete the
following steps.
Attaching the Extension Legs to the Front Rail Bracket:
1. Align the right extension leg’s bolt holes with the matching set of holes on the front rail bracket (located on the far right
of the bracket).
2. Thread the counter-sunk bolts from the front rail through to the extension leg.
3. Thread a lock washer and hex nut to on the back of the counter-sunk bolt.
4. Secure the counter-sunk bolt to the front rail using an Allen wrench.
Front View Rear View
Attaching the Right Front Rail to the Table:
1. Align the front bracket’s through holes with the through holes on the front of the table.
The front rail bracket has three through-holes which should align with the last three through-holes on the front
of the table located on the far right as shown.
2. Thread three counter-sunk screws through each of the front rail’s through-holes.
3. Thread the flat washers and hex nuts onto the back of each counter-sunk bolt.
4. Use a level to ensure that the front rail is level to the table. If needed, you may adjust the height of the extension leg to
level the bracket with the table.
5. After the bracket has been leveled, tighten the counter-sunk bolts with the wrench provided to secure the bracket to the
table.
After completing step four, there should be two through holes in the middle of the front rail bracket which
have not been used yet. These should be empty as they will be used to mount the right
extension table later.