laguna Fusion F3, Руководство пользователя

Страница: 22 / 68

Fusion F3 Table Saw - Setup - Unboxing 22
© 2020 Laguna Tools
Unboxing
Your Fusion F3 table saw was carefully packaged for safe transport. The table saw should arrive attached to a wooden
pallet and covered by a wooden crate housing the table saw and its accessories. When unpacking your machine, separate
all enclosed materials to ensure that there are no damages to the parts you’ve received. See pages 6-7 to cross reference
the parts you should receive with your table saw.
This machine is heavy. If you have any doubt about the following unboxing or set up procedures seek
assistance from an experienced professional. DO NOT attempt any procedure that you feel is unsafe or that you feel you do
not have the physical capability of achieving.
Do not cut deep into the wooden crate with a blade as it may scratch the paint of the table saw. To prevent
this, only use a dull edge or cut deep enough to only puncture the tape.
Before setting up your machine, organize all additional set-up tools.
The package will arrive fitted to a wooden pallet.
Quick Reference Guide
Add. Required Tools:
·
Phillips head Screw Driver
· Standard wrench
· Shop Rag
·
WD40 (Cleaning solvent)
Troubleshooting/Tips:
Use at least two people to lift the wooden crate covering the table saw and its
accessories.
For this assembly, you will need:
·
Packaged Fusion F3 Table saw
· 13 mm socket wrench or general wrench
1) Using a Phillips head screwdriver, remove the screws lining the bottom of the wooden crate. This will release the crate
covering from the wooden pallet.