Fusion 3 Table Saw \ Safety \
8
© 2020 Laguna Tools
Table Saw Operating Procedure Warnings
1. Turn off the table saw and disconnect the power cord when removing the table insert,
changing the saw blade or making adjustments to the riving knife, anti-kickback device or saw blade guard, and when
the machine is left unattended. Precautionary measures will avoid accidents.
2. Never leave the table saw running unattended. Turn it off and
don’t
leave the tool until it comes to a complete stop. An
unattended running saw is an uncontrolled hazard.
3. Locate the table saw in a well-lit and level area where you can maintain good footing and balance. It should be installed
in an area that provides enough room to easily handle the size of your workpiece. Cramped, dark areas, and uneven,
slippery floors invite accidents.
4. Frequently clean and remove sawdust from under the saw table and/or the dust collection device. Accumulated
sawdust is combustible and may self-ignite.
5. The table saw must be secured. A table saw that is not properly secured may move or tip over.
6. Remove tools, wood scraps, etc. from the table before the table saw is turned on. Distraction or a potential jam can be
dangerous.
7. Always use saw blades with correct size and shape (diamond versus round) of arbor holes. Saw blades that do not
match the mounting hardware of the saw will run off-center, causing loss of control.
8. Never use damaged or incorrect saw blade mounting means such as flanges, saw blade washers, bolts or nuts. These
mounting means were specially designed for your saw, for safe operation and optimum performance.
9. Never stand on the table saw, do not use it as a stepping stool. Serious injury could occur if the tool is tipped or if the
cutting tool is accidentally contacted.
10. Make sure that the saw blade is installed to rotate in the proper direction. Do not use grinding wheels, wire brushes, or
abrasive wheels on a table saw. Improper saw blade installation or use of accessories not recommended may cause
serious injury.
Содержание Fusion 3
