laguna Fusion 3, Руководство пользователя

Страница: 25 / 81

Fusion 3 Table Saw \ Setup \ Front Rail
© 2020 Laguna Tools 25
Hardware
E
Hex Cap Bolt (30mm)
use with hex nuts(F), lock
washers (E)
2 of 2
Left Side Front Rail Assembly,
F3 Table
H
Lock Washers (8mm)
2 of 8
Left Side Front Rail Assembly,
F3 Table
K
Rubber Feet 2 of 2
Right Extension Leg
Attaching the Rubber Feet to the Right Extension Legs:
1. Locate the threaded holes on the bottom of each of the right extension legs.
2. Thread each rubber foot through the right extension
leg’s
bottom threaded holes.
3. Hand-tighten each foot to start. Later, the foot may need to be loosened or tightened in order to properly level the front
and rear rails.
Correctly installed foot:
NOTICE!
You may assemble both right extension legs at this step, though only one will be used to complete the following
steps.
Attaching the Extension Legs to the Front Rail Bracket:
1. Align the right extension
leg’s
bolt holes with the matching set of holes on the front rail bracket (located on the far right
of the bracket).
2. Thread the counter-sunk bolts from the front rail through to the extension leg.
3. Thread a lock washer and hex nut to on the back of the counter-sunk bolt.
4. Secure the counter-sunk bolt to the front rail using an Allen wrench.