-9-
www.igmtools.com
Tools needed: Hex wrench
Receiving
It is likely that your machine will be delivered by a third party. Before
unpacking, be sure to inspect the packaging and shipping documents
supplied by the driver. If any damage has occurred because of shipment,
note the damage on the bill of lading or refuse the shipment. Immediately
call the dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying
the shipping company and the purchasing store.
Stand unpacking
Fig. 17
Fig. 17: Unpacking Revo 1216 Expansion Set 254 mm. (1) Delivery
contents. (2) Components unpacked. (2.1) Extension Bed 254 mm.
(2.2) Toolrest Extension. (2.3) Extension Bed Bolts. (2.4) Lock
Handle. (2.5) Outboard Adapter.
Once in place, carefully unpack and remove all components. Unpacking
guidelines:
1. Do not cut deep into a box with a blade as it could scratch the paint.
Only cut deep enough to cut the tape or use a dull edge.
2. Organize the tools needed prior to proceeding with setup.
Components (Expansion Set 254 mm)
Fig. 18
Fig. 19
Fig. 17 - Fig. 19: Unpacking Revo 1216 Expansion Set 254 mm. (1)
Delivery contents. (2) Components unpacked. (2.1) Extension Bed
254 mm. (2.2) Toolrest Extension. (2.3) Extension Bed Bolts. (2.4)
Lock Handle. (2.5) Outboard Adapter.
Inventory
Key
Name
Description
2.1
Extension Bed
Extends the bed length of the
lathe or can be installed to the left
side for outboard turning.
2.2
Toolrest Extension
Only to be used when outboard
turning to raise the toolrest to the
appropriate position.
2.3
Hex Screws
Attaches extension to the end of
the bed or to the lower outboard
turning position.
2.4
Lock Handle
Locks the toolrest extension (2.2)
in place.
2.5
Adapter
Adapter M33 x 3,5 mm
Setup Procedure
1. Make sure the lathe is unplugged and cannot be turned on.
2. Remove the tailstock and banjo (tool rest) by releasing the cam locks
and carefully sliding them out from the right side of the lathe.
Fig. 20
3. The bolt holes are pre-tapped. Lightly tighten all 3 screws (Key 2.3) and
slide the extension into the right side.
4. Reattach toolrest and tailstock. Position the tailstock so that half rests
on the bed and half rests on the extension (Fig. 20). Align the extension
and the bed, then tighten the screws.
2.5
Bed Extension
