-10-
www.igmtools.com
Fig. 21
5. Place the tailstock on the main bed for safe keeping.
6. The bolt holes are pre-tapped. Lightly tighten all 3 screws (Key 2.3) and
slide the extension into the left side.
7. Remove hand wheel or faceplate from left spindle threading.
8. Loosen outboard adapter set screws, lock spindle and screw in the
outboard adapter (Key 2.5).
9. Install the banjo on the extension by carefully sliding it into the left side
of the extension.
10. Install the toolrest extension (Key 2.2) into the neck of the banjo.
11. Install the lock handle (Key 2.4) into the toolrest extension (Key 2.2).
12. Install the toolrest into the toolrest extension (Key 2.2).
IGM LAGUNA Revo 1216 Adjustable Stand
Order code: 151-1216STA
Compatibility: 151-1216
Fig. 22
Fig. 23
Fig. 23: Revo 1216 Adjustable Stand. Includes adjustable lathe
stand and a tool rack. (1) Lowest position 990 mm (floor to spindle
centreline). (2) Highest position 1143 mm. (3) Tool Rack - holds
faceplate, both centres, knockout rod, 9 chisel tools with 25 mm
holes and 4 large tools with 34 mm holes. (4) Rubber Pads.
Revo 1216 Adjustable Stand Setup
WARNING!
Unplug the machine from power source!
CAUTION!
Two persons are required in this setup.
TIP
Do not over torque the threading, only firm pressure is required.
Tools needed: Additional person, 6 mm Hex wrench, Phillips head
screwdriver and open ended wrench.
Receiving
It is likely that your machine will be delivered by a third party. Before
unpacking, be sure to inspect the packaging and shipping documents
supplied by the driver. If any damage has occurred because of shipment,
note the damage on the bill of lading or refuse the shipment. Immediately
call the dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying the
shipping company and the purchasing store.
Stand unpacking
Fig. 24
Fig. 24: Unpacking Revo 1216 Adjustable Stand. (1) Contents. (2)
Stand in a box. (3) Contents unpacked.
Once in place, carefully unpack and remove all components. Unpacking
guidelines:
1. Do not cut deep into a box with a blade as it could scratch the paint.
Only cut deep enough to cut the tape or use a dull edge.
2. Organize the hardware and setup tools needed prior to proceeding with
setup.
Outboard Turning
Bed
